Dirty Electricity filters remove electromagnetic interference (EMI) and dirty power from home or office wiring, thus reducing harmful electromagnetic fields (EMF).
Updated: March 3, 2017
Dirty electricity is found in a range of frequencies. A filter must have filtration capabilities that target both high and low sections of the frequency spectrum. Both Graham Stetzer (Stetzerizer) filters and Greenwave filters do this. Here we discuss Greenwave.
Greenwave® Spectrum 2000 Series filters (2400G and 2500G models) target low and mid-range frequencies and the Greenwave® Broadband 1500G filter targets mid-range and high frequencies. When you buy Greenwave filters from us, we provide a mix of these filters for optimal dirty electricity (EMI) reduction.
Greenwave filters remove erratic micro-surges of energy from wiring, helping to normalize electrical current, and thus reducing health risks.
Features of the Greenwave Dirty Electricity Filters
EFFECTIVENESS: Very good.
COST: Greenwave are $25.00 – $28.00 USD per filter.
BUILT-IN OUTLET: Greenwave filters have a built-in outlet at the base of the filter, Stetzerizers do not. Thus with Greenwave, you don’t lose the use of an outlet.
CAN STOP EMI AT THE SOURCE: Greenwave filters reduce dirty electricity traveling along electrical wiring in a building.
They can also help stop dirty electricity at its sources, that is, the electronics and other electrical equipment that create it. When you plug a device into the base of a Greenwave filter rather than directly into a wall outlet, dirty electricity created by the device will be filtered before it reaches the internal wiring of the building.
Conclusion: Greenwave filters are a very good way to reduce dirty electricity in your home or office. They absorb and dissipate the dirty electricity, reducing dangerous electromagnetic energy by 50 to 95%. Our research has concluded that Greenwave represents the optimal design, so that’s the one we recommend.
Deploying the filters:
I usually install 12-20 filters in a home, depending on size. I measure each outlet and then place the filters strategically and they work together to harmonize the home into a cleaner electrical state. Rule of thumb: Two Greenwave filters are needed to reduce dirty electricity in an average room. Rooms with concentrations of electronics may require more than two filters (usually 3), while smaller rooms, such as bathrooms and laundry rooms, usually require only one.
I’ll help you install Greenwave filters as part of my EMF Housecheck inspection.